Residential Electrical Services in Lawrenceville, GA
New circuit runs, aluminum wiring remediation, knob-and-tube replacement and whole-house rewiring — modern copper, properly permitted.
Old wiring doesn't announce itself until something goes wrong — a breaker trips for no clear reason, an outlet feels warm, or a room just stops getting power. We repair, extend and replace household wiring so it can actually handle what your home asks of it today.
Overview
Wiring problems tend to hide behind walls, which is exactly why they get ignored until they can't be. Whether it's a single damaged run feeding one room or an entire house full of wiring that was never sized for modern life — think window units, computers, and everything else we plug in now — we'll walk the property, tell you what we're actually seeing, and give you options instead of a one-size-fits-all fix.
A full rewire replaces every branch circuit and usually pairs with a new panel. It's warranted for knob-and-tube, widespread deteriorated insulation, or a home being taken down to the studs anyway. A partial rewire targets the worst circuits — kitchen, baths, bedrooms, or a specific area — and is often the right call for a home that's mostly sound. We assess and tell you honestly which you need.
If your home has aluminum branch circuits, a full rewire isn't the only option. We remediate connections with approved methods — AlumiConn or COPALUM connectors at every device and junction — which many insurers accept as a permanent fix at a fraction of rewire cost.
We fish wiring through attics, basements, crawlspaces and interior wall cavities to reach most locations without opening long channels in the drywall. Where access holes are unavoidable, we keep them small and located for easy patching, and we walk you through the plan before we start.
Lawrenceville homes built in the late 1960s through mid-1970s may have aluminum branch wiring. Aluminum isn't inherently dangerous, but it expands and contracts more than copper with each heating cycle, which loosens connections over time. Loose connections arc, and arcing starts fires. The fix isn't necessarily a full rewire — in many cases, we can remediate aluminum wiring with approved copper-to-aluminum connectors (COPALUM or AlumiConn) at every termination point: outlets, switches, fixtures and the panel. It's less disruptive and less expensive than a rewire, and it brings the risk down to the same level as copper.
If you're adding circuits or rewiring any part of your Lawrenceville home, current code applies to the new work. That means AFCI protection on bedroom circuits, GFCI protection in wet locations, tamper-resistant receptacles throughout, and 12-gauge minimum on 20-amp kitchen and bathroom circuits. We wire to the current NEC as adopted by Georgia, and we pull the permit so the county inspector signs off on it. Code compliance isn't red tape — it's the baseline that keeps your wiring insurable and your family safe.
We provide electrical wiring and rewiring across Lawrenceville and nearby communities including Suwanee, Duluth, Snellville, Grayson, Dacula, Lilburn and Buford, plus much of metro Atlanta — Buckhead, Brookhaven, Sandy Springs, Chamblee, Midtown, Druid Hills and more. Our electricians are Georgia-licensed, insured, and familiar with local permit and inspection requirements.
We repair, extend and replace household wiring, from a single damaged run to whole circuits that were never sized for modern loads.
Who We Serve
Homes and businesses across Lawrenceville, Gwinnett County and metro Atlanta.
New circuit runs, aluminum wiring remediation, knob-and-tube replacement and whole-house rewiring — modern copper, properly permitted.
Commercial wiring upgrades, additions and replacements for offices, retail and restaurants that need more or better circuits.
Why Us
Your wiring is the one thing every outlet, light and appliance depends on.
Every repair and installation carries a written workmanship warranty, plus manufacturer warranties on the parts we supply.
Georgia-licensed electrical contractor, fully insured, and every technician is background-checked and uniformed.
Shoe covers, drop cloths, and we haul away the old material. We explain what we did and why before we leave.
You approve a clear price before any work begins, with same-day appointments and true 24/7 emergency response.
Service Area
Based at 241 Lawrenceville Hwy, we serve Lawrenceville, Gwinnett County and communities across metro Atlanta. Full list in the footer below.
Licensed electricians for every job in your home or business — pick a service to see how we handle it.
FAQ
The clearest signs are frequent breaker trips under normal load, outlets that spark or feel warm, a burning smell you can’t trace, and two-prong (ungrounded) outlets throughout the house. If your home was built before 1975 and still has the original wiring, an inspection will tell you definitively. Homes with knob-and-tube, cloth-insulated or aluminum branch wiring are the highest-priority candidates.
No. We route new wiring through the attic, crawlspace and interior wall cavities wherever possible, using targeted access holes rather than stripping walls. A typical ranch with attic and crawlspace access needs relatively few drywall cuts. A two-storey with finished walls on every floor requires more, but we plan the route to minimise them. We patch and prime every opening we make.
Not necessarily. Aluminum wiring itself isn’t dangerous — it’s the connections that fail. Approved remediation methods (COPALUM crimps or AlumiConn connectors) make every aluminum-to-device connection as safe as copper. Full replacement is an option but costs significantly more. We assess the wiring condition and recommend the approach that makes the most sense for your home’s specific situation.
Yes. A targeted rewire is common during a renovation — you’re opening the walls anyway, so it’s the cheapest time to replace the wiring in that room. We run new copper circuits from the panel to the room, install code-compliant outlets (GFCI/AFCI where required) and a properly sized breaker. The rest of the house stays untouched unless you want to phase the work over time.
Old aluminum, cloth or knob-and-tube replaced with modern copper, grounded and permitted.